GOautodial Open Source Omni-channel Contact Center Suite

can you post the error.

i think it could be the OS issue.
goautodial 3.3 is installed on Centos 5 , which is Out of Support.
Digium drivers needs the latest kernel in current supported OS

better you try install goautodial in centos 7 .

regards
striker
www.striker24x7.blogspot.com

Thanks for the speedy reply.
Any how I already started deploying as per the link available in wiki....
Now, where I can see the card details in GUI, once I install the drivers and how to configure to receive and make calls through GUI?

you cant see the card details in gui
you need to do it in cli.

refer below link
https://striker24x7.blogspot.in/2013/12/how-to-configure-digium-te133-and-te134.html
https://striker24x7.blogspot.in/2015/07/vicidial-or-goautodial-dialplan-entry.html

regards
striker
www.striker24x7.blogspot.com

One more doubt.
Do I need to install asterisk separately, or it is installed along with Goauotdial?
If i need to install do you have any doc for this?
Thanks

its pre-installed in goautoidal

regards
striker
www.striker24x7.blogspot.com

Ok.
Installed successfully. But in asterisk cli when i run the command show dahdi spans am getting blank.
Where am missing?
And also how could I receive call on one (test) extension and dial out manually ( without campaign)
Thanks in advance.

asterisk cli commands to check pri

dahdi show status
dahdi show channels
pri show spans

regards
striker
www.striker24x7.blogspot.com

Thanks for your reply.
Can you help me doing an outbound and receive a call manually? (Without campaign)

Bump

Hi
Your speedy answer will resolve my problem. Pls help me

Experts,
Pls help me.

hope you have you have created dialplan in default context as said in below blog link
https://striker24x7.blogspot.in/2015/07/vicidial-or-goautodial-dialplan-entry.html

once done you can directly dial the no from the phone without campaing

For incoming create the DID in goautodial and destination to the phone

Thanks for the time Striker.
Now I could able to do a manual call from softphone, but unable to receive calls on the extension.
I need help in configuring DID.
Pls help me.

Experts,
Your speedy reply is highly helpful.